Features:
- Operating supply voltage up to 46v.
- Low saturation voltage.
- Total dc current up to 4a.
- Up to 1.5 v of logical “0” input voltage [high noise immunity].
- Overtemperature protection.
L298N Multiwatt Full-bridge Motor Driver IC
The L298 is a monolithic integrated circuit in a 15-lead Multiwatt and PowerSO20 packages. It is a high voltage, a high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. Two enable inputs are provided to enable or disable the device independently of the input signals. The lower transistor’s emitters of each bridge are connected and the corresponding external terminal can be used for external sensing resistor connection. During lower voltage, an additional power supply is provided for the logic to work properly.
L298 is a high power version of the L293d motor driver IC. It is a high voltage, high current, a dual full-bridge driver designed to accept standard TTL logic levels (Control Logic) and drive inductive loads such as relays, solenoids, DC and Stepper motors. Two enable inputs are provided to enable or disable the device independently of the input signals.
Key Specifications:
- Operating voltage range: +5 to +46V.
- Maximum supply voltage:50V.
- Maximum Input and Enable Voltage:+7V.
- Maximum current output: 3A.
Pin Description:
Common Terminals:
- 8 – GND [Connected to GROUND].
- 4 – SUPPLY VOLTAGE VS [Connected to +5V].
- 9 – LOGIC SUPPLY VOLTAGE [Supply Voltage for the Logic Blocks].
H-BRIDGE A
- CURRENT SENSING A Between this pin and ground is connected to the sense resistor to control the current of the load.
- (2) OUTPUT 1,
- (3) OUTPUT 2,
- Outputs of the H- Bridge A. The current flow through the load connected between these two pins is monitored at pin 1.
- (5) INPUT 1,
- (7) INPUT 2,
- TTL Compatible Control Inputs of the Bridge A.
- (6) ENABLE A
- TTL Compatible Enable Input. The LOW state for disable.
H-BRIDGE B
- (15) CURRENT SENSING B Between this pin and ground is connected to the sense resistor to control the current of the load.
- (13) OUTPUT 3,
- (14) OUTPUT 4,
- Outputs of the H- Bridge B. The current flows through the load connected between these two pins is monitored at pin 15.
- (10) INPUT 3,
- (12) INPUT 4
- TTL Compatible Control Inputs of the Bridge B.
- (11) ENABLE B
Applications:
- TTL Compatible Enable Input. The LOW state for disable.
- TTL control inputs.
- Total power dissipation:25W.
- Operating temperature: -23°C to 130°C.
- Storage Temperature: -40°C to 150°C.
Here are a few areas where L298 is preferred:
- L298 is used where H- BRIDGE is required.
- Where a high power motor driver is required. In the market, there are H-bridges like L293 which are used for the low powered applications while L298 is specially designed for high power applications.
- Where current control and PWM operable single-chip device is needed.
- The chip is preferred when control unit can only provide TTL outputs
